Requirements for the heating temperature of the plate heat exchanger
The heating temperature of the plate heat exchanger cannot meet the requirements: the first characteristic is that the outlet temperature is low and cannot meet the planned requirements. The main part of the external leak is the seal between the plate, and the two seals of the plate leak, the groove portion and the inside of the end plate and the pressure plate.
Large pressure drop: The pressure drop at the inlet and outlet of the medium exceeds the planned requirements, and is even many times higher than the planned value, which seriously affects the flow and temperature requirements of the system. In the heating system, if the pressure drop on the hot side is too large, the primary flow rate will be seriously insufficient, that is, the heat source will not work, and the secondary outlet temperature will not meet the requirements.
Straight liquid: The first feature is that the medium on the high pressure side is connected to the medium on the low pressure side, and the pressure and temperature in the system are abnormal. If the medium is corrosive, it may also cause corrosion of other equipment in the pipeline. Threading fluid usually occurs in the turning zone or possibly in two sealed zones.
The plate heat exchanger clamps the clamping plate by clamping bolts, which is convenient for disassembly and assembly, and the cleaning device can be opened at any time. Because the surface of the printing plate is bright, turbulence is high and scale is not easy to scale. The plate heat exchanger plate is a separate component that can be added or removed in various forms as needed. It can be applied to a variety of different process requirements.